RHINO RC456 Manuale dell'Operatore Scaricare il pdf (Pagina 11)

The settings on the previous page are only approximate settings. The final position on the wing is determined by the

desired width of the windrow. Moving the rake mounts forward on the wing makes the windrow wider. Moving the rake

mounts rearward makes the windrow narrower.

10. Install the wheel rakes on the mount tube by inserting the rakes main frame tube into the tubes on the rake mounts.

This operation can be made easier if the carrier is connected to the tractor tongue, hydraulics are connected and the

wings are extended. Install the clamps on the rake tubes. Tighten the 1/2" x 1 1/2" bolts, nuts, and lockwashers

snugly. The ears at the top of the clamp should be on either side of the tab on the mount tube so the rake can "float"

as it works.

Important: When the rake is positioned correctly, drill a hole through the clamp and the rake tube and install a 5/16"

shear bolt, lockwasher, and nut (See Illustration 3).

Before operating this machine, lubrication of specific parts must be completed. Lubricate the points listed before

operating for the first time and periodically as shown in the chart (See page 7).

Before operation, check tightness of lug bolts and spindle setscrews.

OPERATION

Important: Before operation, the operator should be familiar with these operation instructions and operation of tractor.

Do not allow an unqualified person or one under the influence of medication or intoxicating substances to operate the

tractor.

1. Connect the machine to the tractor tongue using a 3/4" hitch pin with a retaining clip. The adjustable jack will allow

the tongue to be raised or lowered during hookup. After hookup to the tractor, store the jack in the horizontal position.

2. Connect the hydraulic inlet and outlet hoses to the tractor hydraulic system.

CAUTION! Make sure a restrictor is installed on one of the hydraulic lines. Failure to use a restrictor will allow the

machine to fold and unfold rapidly and could result in damage to the machine, and injury to bystand-

ers.

3. To lower the rakes to the working position, pull the transport pins for each wing and apply hydraulic pressure to

retract the cylinder. The wings will spread apart and the rake will lower to the working position as the castor wheels

move down the axle ramps. The transport pins can be stored in the raised position by installing clips in upper holes.

CAUTION! Operate the hydraulic cylinder through the cycle a few times to expel all air through the system.

Failure to fully charge the hydraulic system could result in injury when the rakes fall abruptly to the

ground.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Nessun commento

RHINO RC456 Manuale dell'Operatore Pagina 11